F70SL 17.3 INVERTER CABLE 1410-003N000
Category : LCD Cable
In most cases you should see listed above cited reference F70SL 17.3 INVERTER CABLE 1410-003N000 if this is not the case, check uploaded photos.
Symptoms of a faulty LCD cable
Most of the time a defective cable F70SL 17.3 INVERTER CABLE 1410-003N000 causes sizzle on the screen when you move your computer screen .
You can also see if the cable is really broken a blank screen, look this symptom can also mean that your monitor or the graphics card in your pc a problem.
In very rare cases, there may be a problem as RGB color on your screen while still in this case, it may be due to your monitor or graphics card
How to change your cable F70SL 17.3 INVERTER CABLE 1410-003N000 effectively?
First put the gloves antistatic to avoid any risk of short circuit when handling your notebook . You will remove the screen from the top of the computer and remove the front of the hull before , remove the hinges and fold the screen, most of the time you need to remove the tape that serves as protection to unclip the horizontal (so straight) cable connector F70SL 17.3 INVERTER CABLE 1410-003N000 Do not try to pull up because you will deform the metal part and there will be the game that will cause poor interconnection.
Then following computers it will remove the front bezel or outright all or part there is the touchpad to access the connector on the motherboard take care to recover from a vertical connector of your F70SL 17.3 INVERTER CABLE 1410-003N000 otherwise you will bend the pins on the motherboard and it should replace the motherboard.
Between the two there is also just unclip the cable connector located on your inverter. (I note that the new models , there is more because they have a inverter LED technology. Careful though, do not pull the plug and not the son, because there is a risk that you cassiez one.
Once reassembled, it is important to put a new tape on connectivity at the top of the screen.